Constraint Boundary Time-at-Risk (CBTR)

GMI-PI-001Process IndustriesPilot-ReadyPattern R-4: Margin Consumption

Definition

Percentage of operating time the APC or RTO holds an integrity-relevant process variable within a defined proximity band of its asset integrity limit, measured per equipment item and per variable to detect whether optimization is consuming the engineering margin between operating targets and metallurgical or design constraints.

The Measurement Gap

The new decision is whether the APC's continuous push toward yield, throughput, or severity is consuming asset integrity margin in ways that compound across thousands of hours of operation. The failure mode is silent: every legacy dashboard reports green while the asset ages faster than the inspection program assumes. Throughput, conversion, yield, and energy intensity all measure what was produced: none of them measure the operating conditions that produced it. On-stream factor and unplanned outage frequency are lagging indicators that only register after damage has manifested. Corrosion rates from inspection cycles capture cumulative damage but cannot attribute it to operating intensity. None of these metrics has a temporal dimension that can answer the operative question: how many hours did the unit spend in the upper ten percent of the operating-to-limit range, and on which variables?

Decision Supported:

Is the APC pushing process conditions close enough to integrity limits, for long enough durations, that the asset is aging faster than the inspection program assumes, and if so, which limits and which equipment are most exposed?

Formula

Plain language: Add up every hour the variable spent inside its proximity band of the integrity limit, divide by total operating hours in the period, multiply by one hundred. Compute per equipment item and per integrity-relevant variable.

Notation:

CBTR_jk = ( Σ t_within_band_j ) / T_total × 100

The proximity band is defined as the top 10 percent of the operating-to-limit range, configurable per variable. Computation is performed per equipment item k and per integrity-relevant variable j.

Variables:

Variable Definition Unit
t_within_band_j Hours that variable j spent within its proximity band during the measurement period hours
Proximity band Top 10 percent of the range between operating target and integrity limit, configurable per variable dimensionless range
T_total Total operating hours in the measurement period hours
Integrity limit Design temperature, MAWP, or metallurgical limit established by integrity engineering engineering unit
j Index of integrity-relevant process variable (temperature, pressure, vibration) n/a
k Index of equipment item n/a

Proposed formula, pending validation pilots.

At a Glance

Unit
Percentage
Trend Direction
Lower
Reporting Frequency
Monthly
Category
AI Process Optimization Integrity
← APC Model-Plant Mismatch Index (APMMI)Multi-Objective Tradeoff Drift Index (MOTDI) →

Assess Your Organization

The AI-GPS Assessment evaluates your AI governance maturity and recommends KPIs like this one for your implementation roadmap.

Take the Free AI-GPS Assessment