QA Verification Time Adequacy Ratio (QVTAR)

GMI-NUC-025Nuclear OperationsPilot-Ready

Definition

Ratio of actual time available for QA hold point inspections, concurrent verifications, and post-maintenance walkdowns to the standard time allocation for those verification activities, measuring whether AI-compressed schedules are squeezing quality assurance margins.

The Measurement Gap

AI-optimized maintenance schedules compress task durations to improve schedule performance. The compression is applied to productive work time, but it also squeezes the time allocated for QA verification activities: hold point inspections, concurrent verifications, and post-maintenance walkdowns. No legacy metric measures whether verification activities receive adequate time. Schedule compliance tracks whether work finishes on time. QA inspection completion rate tracks whether inspections were performed. Neither measures whether the inspector had enough time to perform the inspection thoroughly. The invisible failure mode is that AI-compressed schedules allocate verification time that is technically sufficient for a cursory inspection but insufficient for a thorough one, and the inspector, under schedule pressure, performs the minimum rather than the standard. Inspection completion rate stays at 100% while inspection effectiveness silently degrades because the time allocated does not support the thoroughness required.

Decision Supported

Is the AI-optimized schedule providing adequate time for QA verification activities, or are inspectors being pressured to complete verifications faster than the standard allows?

Formula

Plain language: For each QA hold point, concurrent verification, or post-maintenance walkdown, compare the time actually available for the verification (from the schedule) to the standard time allocation for that verification type. The ratio tells you whether the schedule is providing adequate verification time or compressing it.

Notation:
QVTAR = T_available / T_standard

Population:
QVTAR_composite = (1/N) × Σ_i (T_available_i / T_standard_i)

Variables:

  • T_available_i = time allocated in the AI-generated schedule for verification activity i (hours)
  • T_standard_i = standard time allocation for verification activity type i (hours: from QA program standards, procedural time estimates, or historical average verification duration)
  • N = total number of verification activities in the measurement period (count)

Sign convention: QVTAR = 1.0 means verification time matches the standard. Below 1.0 means compressed (bad). Above 1.0 means adequate to generous (good).

Aggregation period: Weekly rolling, with outage-specific reporting.

Edge Cases

  • Verification completed early by an efficient inspector: the metric measures time available, not time used. An efficient inspector who completes in 20 minutes when 30 were allocated had adequate time. The concern is when only 10 minutes are allocated and the inspector rushes to meet the schedule.
  • Concurrent verification (two people required simultaneously): available time is the window when both are scheduled to be available, often tighter than the individual allocation
  • Emergency/forced schedule compression (emergent work, extended prior task): tag as "schedule-deviation-driven" compression vs. "AI-planned" compression: QVTAR should primarily measure the AI scheduler's tendency to under-allocate verification time
  • Minimum: all QA hold points and concurrent verifications on safety-related work (census)

Proposed formula, pending validation pilots.

At a Glance

Unit
Ratio
Trend Direction
Toward 1.0
Reporting Frequency
Weekly
Category
Schedule-Driven Risk and Resource Misallocation
← Concurrent Maintenance Risk Density Index (CMRDI)Schedule Dose Alignment Factor (SDAF) →

Assess Your Organization

The AI-GPS Assessment evaluates your AI governance maturity and recommends KPIs like this one for your implementation roadmap.

Take the Free AI-GPS Assessment