Definition
Measures the rate of product quality metric degradation between consecutive maintenance events on the same asset.
The Measurement Gap
Existing maintenance KPIs measure whether maintenance happened on time. Existing quality KPIs measure whether quality is in-specification at the measurement point. No existing metric measures the slope of quality degradation within the preventive maintenance interval. This blind spot matters because many manufacturing assets begin producing subtly degraded output long before they approach mechanical failure. Bearings wear gradually, tooling dulls incrementally, and alignment drifts slowly. The asset continues to function, and quality metrics may still be within specification, but the quality trend is declining steadily between maintenance events.
The decision IMQDR supports is whether the PM interval should be shortened for quality reasons even when the asset reliability data says the interval is adequate. An asset might have a mean time between failure of 90 days but a quality drift rate that pushes Cpk below the plant's quality threshold at 45 days. Without IMQDR, the PM interval stays at 90 days because the asset is not failing. With IMQDR, the organization can see that quality capability at the end of the PM interval is significantly worse than at the beginning, and can either shorten the interval, add a mid-interval quality-focused maintenance action, or increase inspection frequency in the latter half of the interval.
Formula
IMQDR fits a trend line to quality metric measurements between two consecutive maintenance events on the same asset, expressing the slope as quality degradation per day.
IMQDR = (Q_end minus Q_start) / T_interval
Where Q_start is the quality metric value (Cpk, first-pass yield, or dimensional deviation from target) measured shortly after the preceding maintenance event once the asset reaches steady-state production. Q_end is the quality metric value measured shortly before the next maintenance event, using the same metric. T_interval is the elapsed time between the Q_start and Q_end measurements in calendar days.
A negative IMQDR means quality is degrading between maintenances, which is expected for most assets. The question is not whether degradation occurs but how fast. Zero means stable quality between maintenances, which is the ideal state. Larger negative values indicate faster degradation. Units are quality-metric-units per day, so an IMQDR of negative 0.01 Cpk per day on a 60-day PM interval means Cpk drops by 0.6 over the interval.
Edge cases include product changes during the inter-maintenance interval, which introduce different quality baselines. Normalize to the product-specific target or compute IMQDR separately for each product type. Non-linear degradation near end-of-interval, where some assets degrade exponentially as wear accelerates, requires using the last-quartile slope rather than the overall slope to capture the worst-case trajectory. Quality measurements must occur frequently enough to detect the trend. If quality is only measured at final inspection, IMQDR is unmeasurable because there are not enough data points to fit a trend. Minimum sample requirements are three complete inter-maintenance intervals per asset per measurement period.
Proposed formula, pending validation pilots.